schnuggel
2005-06-12, 17:58:15
Mit folgenden Einstellungen bekomme ich ein Blue Screan beim Übertakten.
Was mache ich falsch? Ich möchte doch nur 2400 Mhz erreichen und nicht mehr!
AMD Venice 3500 @ 3800 ( 11x 218 = 2398 Mhz )
HTT auf 800
JumperFree Konfiguration
AI Overclocking [Manual]
CPU FSB Frequency [218 MHz]
CPU Speed/Voltage Setting [Manual]
CPU Multiplier [11] = [Auto]
CPU Voltage [1,4]=[Auto]
AGP/PCI Frequency (MHz) [66.66/33.33]
DDR Voltage [2,7V]*
AGP Voltage [1.5V] = Default
V-Link Voltage [2.5V] = Default
Advanced Chipset:
Memclock Mode: Limit
Memclock Value: 1:2 (DDR400)
Bank Interleaving: Enabled
Burst Length: 8
SDRAM CAS Latency: Auto
SDRAM RAS to CAS Delay (tRCD): Auto
SDRAM Active to Precharge Delay (tRAS): Auto
SDRAM Row Precharge (tRP): Auto
2TCommand: Disabled
Was mache ich falsch? Ich möchte doch nur 2400 Mhz erreichen und nicht mehr!
AMD Venice 3500 @ 3800 ( 11x 218 = 2398 Mhz )
HTT auf 800
JumperFree Konfiguration
AI Overclocking [Manual]
CPU FSB Frequency [218 MHz]
CPU Speed/Voltage Setting [Manual]
CPU Multiplier [11] = [Auto]
CPU Voltage [1,4]=[Auto]
AGP/PCI Frequency (MHz) [66.66/33.33]
DDR Voltage [2,7V]*
AGP Voltage [1.5V] = Default
V-Link Voltage [2.5V] = Default
Advanced Chipset:
Memclock Mode: Limit
Memclock Value: 1:2 (DDR400)
Bank Interleaving: Enabled
Burst Length: 8
SDRAM CAS Latency: Auto
SDRAM RAS to CAS Delay (tRCD): Auto
SDRAM Active to Precharge Delay (tRAS): Auto
SDRAM Row Precharge (tRP): Auto
2TCommand: Disabled